I spent several hours this weekend working on the wing tips. I finished the plate nuts on the right wing tip and fitted the rib that supports the wing tip trailing edge. The left wing tip trailing edge may require a bit of tweaking after the wings are installed and I fit the ailerons. So, I can't fit the tip rib yet, and I need to leave a few holes without plate nuts to make it easier to put the wing tip on and off. So, I'll just do two-thirds of the plate nuts now, and finish the rest after I do any trailing edge work.
I played around with my Brother P-Touch label maker. It took several attempts, but I finally got some nice labels for the pitch and roll trim indicators. Tomorrow I'll attack the labels for the switch console on the right side of the cockpit.
The clear tape for the labels is slightly visible, but it isn't quite as bad as it looks in the picture.