I had planned to finish some wiring under the floor before putting the floors back in, and trying out the seat cushions. Well, I couldn't wait, so last night I slipped the floors in, and put the front seat cushions in. The top of the seat bottom is higher than I had expected, which is a good thing. I slipped the canopy closed, and the top of my head was a few inches from the plexiglas - just right.
After doing some fibreglas work tonight, I wanted to assemble the rear seat back and install it. But, I searched high and low, but I couldn't find two small doublers that I had fabricated many months ago. I remember putting them somewhere "safe", but darned if I can find them now. Tomorrow I'll fabricate them again, which pretty much guarantees that they will show up.